How do you smooth out dents on a car?

How do you fix an indented car?

First, heat the dent with the hairdryer approximately six inches away for about 30 seconds. Then cover the dent with a piece of aluminum foil and rub dry ice over it. The rapid change from hot to cold should make the dent pop out within a minute or so. Another temperature trick involves boiling water.

Can you buff out dents?

Start off by heating the car dent with the hair dryer at its highest temperature, which will expand the plastic of the car. As soon as it’s hot enough, grab the can of compressed air, turn it upside down, and begin spraying that same area. Since the cold air will cause the plastic to contract, the dent will pop out.

How do you get a sharp dent out of a car?

Heat the affected area with your dryer, heat gun, or hot water. Less severe dents may pop out on their own with the application of enough heat. If the dent won’t pop out, use a suction cup or rubber mallet to pull or gently hammer the dent out.

Does hot water fix dents in cars?

Use boiling water

Don’t just limit your use of boiling water for cooking and sanitary purposes. It can also be used to potentially remove unwanted depressions in your vehicle, that is, as long as you have a plastic bumper and are successfully able to access the dent from the backside.

THIS IS USEFUL:  Frequent question: How do I know if my windshield is installed properly?

Can car dents be repaired?

Minor dents are easy to fix. First, take a gun/blow dryer and heat the affected area, and once it gets heated, push the dent from inside and flip it out. Now spray ultra cool air in the area. Dent will easily pop out, or a suction dent puller can be easily used.

What causes small dents in cars?

There are six common causes for small dents in cars—accidents, parking lot mishaps, fallen branches, ice, and our ubiquitous Ottawa potholes.

Can boiling water damage car paint?

While it does work on metal, parts like side mirrors, lights, and wheels will not work. Pouring hot water over metal also has its problems. It could warp the metal out of shape, make it less sturdy; it could even ruin your paint job if your paint isn’t up to par.