How many bolts does a 4l80e transmission pan have?

How many pan bolts does a 4L80E have?

Another disparity between both devices is the number of bolts used to secure the transmission to the engine. Here, there are more number of bolts on the 4L80E due to its larger size. Specifically, there is a gasket of 17 bolts on the 4L80E, while the 4L60E’s pan has 16 bolts.

How many bolts are in a transmission pan?

TH350 / TH400 Transmission Pan Bolt Set of 13 bolts

Use these bolts to secure your transmission pan.

What size are the transmission pan bolts on a 4L80E?

25 10MM HEAD 4L85E MT1 MN8.

What’s the difference between a 4L80 and 4L80E?

Like the 4L60 and 4L80 transmission models, the 4L80E is a 4-speed longitudinally-mounted automatic-shift transmission. The E in 4L80E denotes that the transmission comes with a powertrain control system instead of the mechanically-controlled TH400. The 4L80E can deal with a GVWR of 8000 lbs, indicated by figure 80.

How many gears are in a 4L80E transmission?

There are five gears in a four-speed overdrive transmission: First, Second, Third, Overdrive, and Reverse.

THIS IS USEFUL:  Are car seat head pillows safe?

What’s the difference between 4l60 and 4L80?

While the 4L60E is a standard transmission used in rear wheel vehicles manufactured after 1993, the 4L80E is typically limited to diesel and big block vehicles. The two differ greatly in origin, performance, appearance and price, with the 4L80E being easily the more powerful of the two.

What size are transmission pan bolts?

Pan bolts should be 8mm, probably 20mm long. Start the two rear bolts by hand using your socket. Do not run the bolts up too tight. If you drain the torque you should have drained most of the fluid from it so you can add all the recommended amount but for maybe a quart.

How many bolts hold the transmission to the engine?

8 bolts: Pry bar in the drainage slot between the bellhousing and transmission can be used as a starting point. Block the rear of the engine up using some stacked 4x4s or 2x4s in the gap between the cradle and the rear “wall” of the pan (blocking between the ground and the engine).

How many bolts hold the transmission to the engine f150?

A transmission cross member consists of fasteners at each end that secure it to the truck’s frame, and two bolts that fasten the transmission to the cross member.

How many pan bolts are in a 4l60e?

Matt C nailed it – 16 bolts is the 4L60, 17 bolts is the 4L80.

Does a 4L80 need a computer?

In fact, the rear half of the 4L80E is nearly identical to the TH400, and many internal components are interchangeable between the two transmissions. The only downfall of this swap is that the 4L80E is an electronic transmission that generally requires an additional computer and wiring harness to operate properly.

THIS IS USEFUL:  How many cylinders is a 2 0 L engine?

How much HP can a 4L80E handle?

In short, Performance Automatic yields a 4L80E engineered to handle 700+ horsepower and comparable torque.

Will a 5.3 bolt up to a 4L80E?

Will A 4L80E Bolt Up To A Gen 5 Lt1? Our 4L80E Performance Transmission (up to 800 pounds of performance) work fine with all Gen 5 and 5/5 engines.