How do you get a dent out of a plastic bumper?
Apply Heat to the Dent
Warm the bumper surface with a heat-gun tool if you have one (hot water or a powerful hair dryer will work, too) to make the plastic more malleable. Don’t apply strong heat too closely or hold the heat source in the same spot for too long—either can damage the paint.
Can a plastic bumper dent be repaired?
If they are small in size and confined to one area, these dents can usually be repaired. It’s important that the dent did not result in damage to other portions of the bumper. Auto shops that offer dent repair in Salt Lake City can pull out the dent and repair any paint damage.
How much does it cost to repair plastic bumper?
The average cost to repair plastic bumpers ranges from approximately $150-$450. However, the cost to replace a bumper in the event of extensive damage can be anywhere between $800-$1,300. In many cases, your insurance should cover the repair.
Can I use body filler on plastic bumper?
It is not recommended for body filler to be applied over plastic bumper covers. Most bumper covers are made from a thermo plastic TPO or PP. This type of plastic has a problem with things adhering well. Body filler is designed for steel, galvanized steel, zinc coated steel, SMC, fiberglass, and aluminum.
Can a bumper crack be repaired?
When a technician is inspecting the bumper for damage, they will make note of whether there are any cracks in the bumper. A dent in a bumper can always be pulled out. However, cracking in the bumper cannot be repaired and this affects the structural integrity of this part.
How can I remove dents myself?
Five DIY methods for removing dings, dents from your car
- Try the plunger method. You know how powerful a plunger can be with your plumbing problems? …
- Use hot water for dented bumpers. Bumper plastic is hard for good reason. …
- Hammer out the dent. …
- Pop out the dent with a hair dryer and compressed air. …
- Buy a dent removal kit.
Can car dents be popped out?
Not only can you unclog a drain with a plunger, but you can also get out small- to medium-sized dents out of your car too. Just splash some water on both the plunger and the dent and start pushing and pulling until it pops out. Make sure to use a cup plunger (for sinks), not a flange one (for toilets).